Update (August 7, 2011): Works on Fedora 15 the same as Fedora 13. I selected "Lexmark Z700-P700 USB Printer #1" (I did NOT select the z600:/ z700:/ type urls. Oddly this seemed to show up in several places. Sudo tar -C / -xvzf lexmark-z700-cups-driver-1.1.1.tgzĪdd printer in Adminitration -> Printing. # THEN similarly, use alien to convert to tarballs.Īlien -t lexmark-z700-cups-driver-1.1. Not sure if it matters, but just to note my system is a fresh Hardy Heron 8.04 install. Although I finally got this printer to work using a similar approach, just different drivers. Everything was shifted off the page to the left, about a centimeter. these instructions have been working great for me in the past with different lexmark printers, although my Lexmark z705 is acting weird now. So you can't access your USB device properly. Mount: can't find usbfs in /etc/fstab or /etc/mtabĪs you didn't add the usbfs line to fstab, mount can't mount the filesystem. This will mount the USB filesystem every time you boot, allowing access to USB sudo mount usbfs Usbfs is not a command to be run in a terminal, but as stated above, the whole line shall be added to your fstab file which is located in /etc. Further trying to untar this nonexistent file are usbfs This means there is no file named in the directory you're executing these command in. Mv: cannot stat `': No such file or directory * Restarting Common Unix Printing System: cupsd start-stop-daemon: warning: failed to kill 5057: Operation not permittedĬupsd: Child exited with status ubuntu mv lexmarkĬupsd: Child exited with status mv lexmark Mount: can't find usbfs in /etc/fstab or /etc/rc2.d/S19cupsys restart Tar: Error exit delayed from previous usbfsīash: usbfs: command not /proc/bus/usb usbfs devgid=14,devmode=0660 0 0īash: /proc/bus/usb: is a sudo mount usbfs Tar: Error is not recoverable: exiting now Tar: : Cannot open: No such file or directory Mv: cannot stat `': No such file or tar -xvzf Should you be able to advise me a different method I would be very pleased to hear from you I have tried numerous times to follow your instructions however as you can see in the included actions I seem to encounter a stumble block. There you have it! If you need any help, post to this thread. Make sure you select the z600 driver, and you're golden.įor KDE users.well, you'll have to use whatever printer dialogue that KDE provides. Now simply set up your printer through the System->Administration->Printing in gnome. Usbfs /proc/bus/usb usbfs devgid=14,devmode=0660 0 0 $ sudo gunzip # unzip the ppd, which should _not_ be gzipped $ sudo ldconfig # DO NOT SKIP THIS STEP or your printer backend won't find required libraries $ sudo tar xvzf z600cups-1.0.tgz -C / # extract the tgz's to / putting the files in their right place $ sudo tar xvzf z600llpddk-2.0.tgz -C / # extract the tgz's to / putting the files in their right place $ alien -t # convert unusable rpm packages to tgz. $ tar -xvzf # extract the contents produced by tail use `tail` to extract the binary portion of the script. $ tail -n +143 .sh > # the sh script is broken for newer systems. $ mv lexmark # move the package to a folder.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |